Samsung OfficeServ 500 Service Manual page 98

CHAPTER 5. Maintenance
3.2.2 Loading the File with Qmodem
1) Exeute qmodem.exe on the DOS window. This description explains how to load
a file if the installed qmodem version is 'SST V3.1a'. If another qmodem
version is used, refer to the relevant manual.
2) Click the [Alt+P] key to set the modem value. Then the <Set Modem Speed>
window will show up.
3) Click the [ENTER] key, and check if the <8WLI> prompt is generated or not on
the main window. If the <8WLI> prompt is not generated, the user shall verify
the cable status, the traffic port status of PC, and the setting status of the modem
configuration parameter.
4) Enter the 'flo' command at the <8WLI> prompt. Then a new message will be
displayed.
<WLI> flo
============== Select One =============
[1] Single WLI
[2] Multi WLI
[3] Restart
5) Enter '1' and select [1], and then the following message will be displayed on the
main window.
Selected 1> Single – WLI HEX FILE Loading
Please Start Loading !!
6) Click the [Page-Up] to load the selected ROM file to the 8WLI card. Then the
following message will show up.
**[ Upload Protocols]**
* A) Ascii
* X) Xmodem
* C) Xmodem CRC
*R) Relaxed Xmodem
*Y) 1K-Xmodem
*B) Ymodem Batch
*Your choice ?
**********************
Page 5-22
OfficeServ 500 Wireless LAN Service Manual/Ed.00
HEX FILE Loading <Addr = 0x00110000>
HEX FILE Loading <Addr = 0x00190000>
*
*
*
*
*
*
*
© SAMSUNG Electronics Co., Ltd.