OfficeServ 500 Wireless LAN Service Manual/Ed.00
1.4 Programming Procedure
This section describes the overall programming procedure. The procedure shall be
read carefully and thoroughly understood.
The programming procedure is described as follows.
Program Procedure
1) Press the [TRSF] button, and enter 800.
2) Enter the PASSCODE
(Operator or Engineer password).
3) To enter the MMC, press the dial button [1] or
select the 'ENABLE' status by pressing the
[UP & DOWN] button.
4) Enter the program number.
Or, select the program number using the [UP & DOWN] button, and press [SPK].
Or, in an idle mode, press the [TRSF] button and enter the program number.
5) Proceed programming of the selected program.
© SAMSUNG Electronics Co., Ltd.
CHAPTER 4. MMC Programming
Display Screen
PROGRAMMING MODE
ENTER PGM ID:
ENABLE TECH PROG
PASSCODE:****
ENABLE TECH PROG
DISABLE TENANT:1
Page 4-3