Basic Operation - Avaya 3600 Series User Manual

Avaya Inc.

Basic Operation

Turn the WT on Press and hold the
Turn the WT off While in standby mode, press and hold the
Make a call or
go off hook
Select a line If multiple lines are available, your telephone system may require
Dial a number Dial calls with the WT exactly as with your desk phone. You may
Answer a call The WT will ring or vibrate to alert you to an incoming call.
Headset answer When a headset is plugged into the WT, the
Hang up To hang up, press the
Unlock Keypad Press the
Lock Keypad Press
Change speaker volume You may increase or decrease the volume of the speaker while in
Change ring volume You may increase or decrease the ringing volume on the 3626
Silence while ringing You may silence a ringing WT by pressing the
Backlight The backlight comes on when any key is pressed or when there is
21-300632, Issue 1, July 2005
Desktop Charger, Dual Charger, and Quad Charger User Guide
Power On
chirps sound. Release the key. The in-service tone sounds and the
extension number displays. The WT is now in standby mode,
ready to make and receive calls.
chirp sounds and the WT turns off. The WT cannot be directly
turned off during a call. End the call first and then turn the WT
off.
Start Call
Press the key and then dial the number.
you to select a line before dialing a number. Press the
and the number key of the line you wish to use. You will hear a
dial tone.
dial extension numbers, internal numbers, or make external calls,
depending on the setup of your PBX. You willhear a dial tone,
then press the number keys to dial the number.
Additionally, a line number on the display may flash, and the
display may show information about the call, such as caller's
name and extension.
To answer a call, press the
your ear and speak with a normal tone of voice.
If you are on a call and hear subdued ringing, a call is coming in
on a second line. The line number on the display may be flashing.
To answer this call, put your first call on hold and press the
key, then press the line number of the second call.
#
key may be pressed to answer a call.
End Call
of each call.
Unlk
softkey, then
FCN Select
, then , to activate
menu.
a call by pressing the corresponding
located on the left side of the WT.
WT by pressing the corresponding
on the left side of the handset while it is ringing.
This action does not interrupt the call and the caller may leave a
voicemail message. Ringing volume may not be changed.
an incoming call and stays on for ten seconds. It turns off after ten
seconds if another key is not pressed within that period.
key for about one second, until two
Power Off
Start Call
key, hold the earpiece to
Start Call
key. Be sure to do this at the end
#
, to unlock the keypad.
Lock Keys
on the Standby
Up Down
and
Up Down
and buttons located
End Call
key. One
LINE
key
LINE
0 – 9, *
, or
buttons
button.
Page 10