Connect To Wireless Local Area Network; Connect To Wireless Wide Area Network (Optional) - Dialogue M2A1 User Manual

Connect to Wireless Local Area Network

Your computer is built-in with a wireless local area networking module that meets IEEE
802.11 b/g standard, which enables your computer to connect to any Access Point within
the signal radius that meets the same communication standard and permits the accessing.
Once your computer is connected to an Access Point, you will be able to access the files
and services shared by the computers or devices on that network. And of course your
computer can enable file sharing for other network users to access your computer. A
wireless system also works in an ad-hoc mode (also known as peer-to-peer mode), in
which wireless devices communicate with each other directly and do not use an access
point.
Enable WLAN Module
Press Fn + F9 or the WiFi button in Control Center to
enable WLAN module. The blue dot lights when the
module is enabled.
1. Once the module is enabled, the Connect to a network wizard will open automatically
and scan for the available networks within wireless signaling coverage.
Connect
When a network is connected, the networking icon in the notification area will turn to green
; otherwise it appears white with a red cross on it
If you are trying to connect to the internet for the first time, or the utility cannot find any
network, you will be asked to set up a connection. Select a network that is found to make
up the connection with your connection utility.
For more information about changing connection, switching between connection modes
and the advance setting and usage of your connection utility, see the Help files of your
connection utility or operating system.

Connect to Wireless Wide Area Network (Optional)

Your computer is optionally equipped with a WWAN module that uses cellular carriers for
data transmission, by which the voice deliverance and data transmission can be made
wirelessly at a very high speed. To connect to WWAN, you must have an access account
and a SIM card and dialing profile from your wireless WAN service provider. The SIM card
acts as an access permission key for your account.
To set up a WWAN connection:
Install SIM Card
1. Power off your computer and remove the battery pack.
2. Find the SIM card slot in the battery
.
- 22 -