Connect To Local Area Network - Dialogue M2A1 User Manual

such as resolution adjustment.
Connect External Display
1. Connect the signal cable of the external
display to the D-sub connector on your
computer.
2. Press Fn+F1 to switch between displays.
Press Fn+F1 repeatedly to switch among
three display modes: computer display only,
external display only, and both.

Connect to Local Area Network

Your computer is built-in with Ethernet
controller chip. Through the RJ-45
connector on your computer, your
computer can connect to local area
network and access the internet.
To make LAN connection:
1. Click the 8P8C plug of Ethernet cable
into the RJ-45 connector on your
computer.
2. Once Ethernet cable is connected, the internet can be connected automatically if you
have already done the IP configuration or the default IP configuration can be validated.
If the connection cannot be made, contact your network administrator or look up in the
manual of the operating system.
To break the connection, unplug the Ethernet cable from the RJ-45 connector on your
computer.
- 21 -