Factory Default Settings - NETGEAR GS908E User Manual

8-Port Gigabit Ethernet Smart Managed Plus Switch Model GS908E

Factory Default Settings

You can return the switch to its factory default settings. Use the end of a paper clip or some other similar
object to press and hold the Reset button on the bottom panel of the switch for more than five seconds. The
switch resets and returns to the factory settings that are shown in the following table.
Table 2. Factory default settings
Feature
Access point login and discovery
IP address
Login password
Switch discovery protocols
QoS
QoS mode
Port priority
Port rate limits
Flow control
Broadcast filtering
Port storm control rate limits
Multicast
IGMP snooping
Blocking of unknown multicast
addresses
IGMPv3 IP header validation
Static router port for IGMP
snooping
Ports and LEDs
Port link speed
Port LEDs
Power LED
Default Setting
DHCP client. Enabled. That is, an IP address is issued to the switch by a DHCP
server in the network.
Standalone IP address. 192.168.0.239 with subnet mask 255.255.255.0
password
All enabled (UPnP, Bonjour, and NSDP)
Port-based
High (all ports)
None (for all ports)
Disabled
Disabled
None (for all ports)
Enabled
Disabled
Disabled
None
Autonegotiation
Enabled
Enabled
Factory Default Settings and Technical Specifications
75