Cisco Asr 9000 Series Aggregation Services Router Modular Quality Of Service Configuration Guide, Release - Cisco ASR 9000 Series Configuration Manual

Configuring Access Node Control Protocol
SUMMARY STEPS
1. configure
2. ancp an-port circuit-id Access-Loop-Circuit-ID [interface type interface-path-id | interface Bundle-Ether
bundle-id] RP/0/RSP0/CPU0:router(config)# ancp an-port circuit-id circuit1 interface gigabitethernet
2/0/1/1.1
3. end or commit
4. show ancp an-port {circuit-id Access-Loop-Circuit-ID | interface type interface-path-id | interface
Bundle-Ether bundle-id | mapping} [statistics | detail]
5. show ancp an-port [configured | dynamic-only][statistics]
6. show ancp an-port summary [statistics][detail]
7. clear ancp an-port {all | circuit-id Access-Loop-Circuit-Id | interface type interface-path-id | interface
Bundle-Ether bundle-id | neighbor {description string | sender-name {H.H.H | A.B.C.D}}[statistics]
8. show ancp an-port {description description-string | sender-name {H.H.H | A.B.C.D}}
9. show ancp an-port state [up | down | none] [statistics]
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)#
Step 2 ancp an-port circuit-id Access-Loop-Circuit-ID
[interface type interface-path-id | interface
Bundle-Ether bundle-id]
RP/0/RSP0/CPU0:router(config)# ancp an-port circuit-id
circuit1 interface gigabitethernet 2/0/1/1.1
Step 3 end or commit
Example:
RP/0/RSP0/CPU0:router(config-ancp)# end
or
RP/0/RSP0/CPU0:router(config-ancp)# commit
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide, Release 6.1.x
Mapping AN Ports to VLAN Subinterfaces
Purpose
Enters global configuration mode.
Defines a unique access node ID. This ID information is
included in the ANCP Port Up and Port Down messages.
The Circuit ID must be supplied before the access node port
configuration can be committed.
When using a shared policy instance in subinterfaces with
ANCP, the same AN port circuit ID must be mapped to all
subinterfaces that have the same shared policy instance.
Saves configuration changes.
• When you issue the end command, the system prompts
you to commit changes:
Uncommitted changes found, commit them before exiting
(yes/no/cancel)? [cancel]:
Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and
returns the router to EXEC mode.
Entering no exits the configuration session and returns the
router to EXEC mode without committing the
configuration changes.
21