Curtis D1000GT12A000 User Manual page 14

PROGRAMMING GUIDE
Programming Options (cont.)
Access Code - sets the access code entered to access programming mode (the factory default is 1-2-3-4).
Once accessed, press
number value (range is 1 to 4). Press
press .
Banner Name - changes the banner name that appears on the display (the factory default is Curtis). No
banner name appears when all blanks are entered. Once accessed, press
change. Then press
change or choose ex and press
P-Maintenance - turns on/off and adjusts the P-Maintenance (preventive maintenance) brew monitor
(the factory default is OFF). When ON, the UCM measures the number of gallons brewed before the
P-Maintenance reminder appears on the display. The range is OFF to 9500 gallons. Once accessed, press
or to choose the desired setting, then, press
Beeper On/Off - turns the beeper that is heard each time a button is pressed on or off (the factory default is
ON). Once accessed, press
Pulse Brew - selects the pulse brew pattern (Pre-Infusion must be off to access, the factory default is C). The
choose the desired setting. Then, press
When Pulse Brew is on, Cold Brew Lock is set within 5ºF and, Cold Brew Lock and Pre-Infuson
disappear from the list of program selections.
Pulse Brew Guidelines
• Filter pack type coffees typically extract better with the A and B pulse setting.
• Decaffeinated coffees typically extract better with the B pulse setting.
• High-yield coffees typically extract better with the C pulse setting. Of course, any of the A, B or C
• Settings D and E are manual pulse counts.
Display Brew Time - turns the display of the brew time during brewing on or off (the factory default is ON).
Once accessed, press
Drip-out Mode -
to drain from the brew basket before the brew basket lock releases (the factory default is 2 min.). This feature
reduces the chance that the brew basket will be removed too early. The range is OFF to 5 minutes. Once
accessed, press
Display Messages - turns display of the message "Rinse Server Before Brewing" ON or OFF (the factory
default is ON). Once accessed, press
Model Select - changes the model number and number of batches (to match the label on the universal control
module, the factory default is D1000GT). Once accessed, press
model number label on the brewer appears, then press
the number of batch sizes on the UCM label, then press
WC-785/WC-789, PROGRAMMING GUIDE
or to choose the number to change. Then press
or to choose the next number to change or choose exit and
repeatedly to change the number value. Press
to exit.
or to choose the desired setting. Then, press
to exit.
or to choose the desired setting, then press
or to choose desired setting, then, press
or
to exit.
to exit.
to choose the desired setting, then press
or
Press or
.
to exit.
repeatedly to change the
or to choose the letter to
or to choose the next number to
to exit.
or
to exit.
to exit.
until the model number matching the
until the number of batches matches
PG8
to
050217NC