Table of Contents
Advertisement
Troubleshooting
POST LED states
Table 6
the POST LED indicators is defined in
page 13.
If the LEDs indicate a failure during POST:
1. Make sure that the HBA is seated firmly in the PCI slot.
2. Verify that the fibre cable connection to the HBA is secure.
Table 6: POST LED states
Amber LED (L1)
Off
On
Slow blink (1 Hz)
Fast blink (4 Hz)
Flashing (irregular)
Off
On
Slow blink (1 Hz)
Fast blink (4 Hz)
Off
32
FCA2684/FCA2684DC PCI-X Host Bus Adapters for OpenVMS and Tru64 UNIX Installation
lists the HBA LED states with descriptions of each state.The location of
Green LED (L2)
Off
Off
Off
Off
Off
On
On
On
On
Blink (1 Hz)
Figure 1
on page 13 and
Description
Wake-up failure (dead board)
POST failure (dead board)
Wake-up failure (dead board)
Failure in POST (dead board)
POST processing in progress
Failure while functioning
Failure while functioning
Normal—1 Gb link rate
Normal—2 Gb link rate
Normal—link down or not yet
started
Table 2
on
Guide
Advertisement
Table of Contents
