Table of Contents
Advertisement
Installing and Configuring Device Drivers
Using the wwidmgr -show adapter command
Use the wwidmgr -show adapter command to view HBA configuration.
The following example shows a display from wwidmgr -show adapter for a
system with two HBAs:
Table 5
Table 5: wwidmgr -show adapter display elements
Item
[0]
kgpsaa0.0.0.4.6
1000-0000-c921-05
ab
fabric
fabric
28
FCA2684/FCA2684DC PCI-X Host Bus Adapters for OpenVMS and Tru64 UNIX Installation
describes the elements of the following display line in detail:
[0]kgpsaa0.0.0.4.6
Description
Item Number
Adapter Mnemonic
The HBA's WWN
Current Topology
Next Topology
1000-0000-c921-05ab
A parameter to the –item qualifier in the
-set adapter command. You can
select which HBA to configure by its item
number. An item number of 9999 selects
all HBAs.
Error messages and displays use this
identifier.
This value identifies the HBA to other
nodes on the fibre channe
The HBA's operating mode for the current
session; either fabric or loop. This mode
is not affected during a wwidmgr session.
The topology setting for the HBA's
NVRAM. Unavail indicates that the
NVRAM is not formatted. Fabric or loop
indicates the HBA's configuration the next
time the system is initialized.
fabric
fabric
Explanation
l link.
Guide
Advertisement
Table of Contents
