Led Indicators; Jumpers; Before You Begin Installation; Led Indicators Activity - HP StorageWorks A6826A Installation Manual

Installing the Adapter

LED Indicators

Table 4
Table 4: LED Indicators Activity
Green LED
(2Gb)
Off Off
On On
1 Flash/s 1 Flash/s
2 Flash/s 2 Flash/s
OFF ON
ON OFF
OFF 5 Flash/s
5 Flash/s OFF

Jumpers

The jumpers on the HBA are set to the default state of the laser and are set at the
factory with a jumper plug on pins 1-2 of the J3 jumper and on pins 1-2 of the J4
jumper.

Before You Begin Installation

The HBA is self-configuring. However, some motherboards require manual
configuration. See the documentation supplied with your computer, or contact
your computer dealer to determine if your motherboard requires configuration.
20
identifies and describes the activity of the LED indicators.
Amber LED
(1Gb)
Both flashing at the same
time like a heart beat.
Alternate flashing. This
state changes to
not-initialized state in 2-3s.
Both LEDs are ON
steadily.
Caution:
Changing the jumper settings can result in the HBA being
inoperable.
A6826A PCI-X Host Bus Adapter for Linux 64-bit Systems Installation Guide
Comments Activity
Power Off
Power On (before firmware
initialization)
Power ON (after firmware
initialization)
Firmware Fault
1G Link UP
2G Link UP
Activity at 1G
Activity at 2G