Map Settings - Mercedes-Benz COMAND Operating Instructions Manual

Map functions
90
To switch to navigation mode: press the
X
ß button.
To show the menu: slide 6 the control-
X
ler.
To select Destination Destination: turn and press the
X
controller.
Select From Previous Destinations From Previous
X
The "Last destinations" memory appears.
To save the destination: select the desti-
X
nation.
The destination address appears.
Store the destination in the address book
X
( page 88).
Y
Save the destination to the SD card
X
( page 89).
Y
To view the details: while in the "Last des-
X
tinations" memory, turn the controller and
highlight the entry.
Slide 9 the controller.
X
A menu appears.
To select Details: press the controller. Details
X
i
The destination address can be changed if
desired.
To delete one or all destinations: while in
X
the "Last destinations" memory, turn the
controller and highlight the entry.
Slide 9 the controller.
X
A menu appears.
To select Delete Delete
X
press the controller.
A prompt appears.
Select Yes Yes or
X
Selecting Yes Yes
nation or all destinations.
Map functions
General notes
Company logos displayed on the map are
trademarks of the respective companies and
used solely for the purpose of indicating the
locations of these companies. The use of such
logos on the map does not indicate approval
Destinations.
or Delete Delete All All: turn and
No. No
deletes the selected desti-
of, support of or advertising by these compa-
nies for the navigation system itself.

Map settings

Setting the map scale
Requirement: the map is in full screen mode,
the menu is faded out (
The lower left-hand section of the map shows
the currently set map scale and compass nee-
dle.
Right-hand-drive vehicles: the currently set
map scale and compass needle are displayed
in the lower right-hand section of the map.
To show the map in full screen mode: to
X
hide the menu, push the % button.
or
Slide the controller to the center of the map
X
and press to confirm.
To set the map scale: as soon as you turn
X
the controller, the scale bar appears on the
bottom of the display.
Turn the controller until the needle points
X
to the desired map scale.
Once you are finished selecting a map
scale, the new map scale will be shown.
page 55).
Y