Setting Up A Mouse Mover - Invacare Linx REM500 User Manual

Scroll
indicator
Bluetooth
status

5.14.1 Setting up a mouse mover

The following set-up procedure assumes that connectivity
cards are available and selectable in one or more profiles and
that the connectivity cards provide mouse mover functions.
It also assumes that the PC or laptop, to which the LiNX
system will connect, has an active Bluetooth connection.
To use a mouse mover function:
1. the LiNX system needs to be paired (via Bluetooth) with
a user's device, and
2. the connectivity card needs to be linked to the paired
device.
The set-up procedure can be performed in any order, but
involves the following:
60101833-A
The scroll indicator
changes from grey
to blue when active.
That is, when the user
input is controlling
the connected device's
scrolling.
The Bluetooth status
indicator shows the
status of the Bluetooth
connection between
the LiNX system and
your device:
• disconnected
• connecting
• connected
• Selecting a connectivity card,
• pairing the LiNX system with a user's device
• linking the connectivity card with the user's device and
• configuring the mouse mover function (cursor speed).
Selecting a connectivity card
For more information about selecting user function cards,
refer to 5.2.1 Using direct navigation, page 28 or 5.2.2 Using
indirect navigation, page 30.
If a connectivity card in the profile has not been configured
fully or is subject to an error, it will be classed as inoperable,
see image above.
There is a number of reasons why a connectivity card is
inoperable. These are:
• the function's primary input is missing,
• there are hardware errors from the Bluetooth module,
• there is no device linked or
• Bluetooth has not been enabled.
For the latter two reasons, the card can be selected as
these are rectified later.
Usage
61