HP FlexFabric 7900 Series Command Reference Manual page 125

Syntax
display ipsec tunnel { brief | count | tunnel-id tunnel-id }
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
brief: Displays brief information about IPsec tunnels.
count: Displays the number of IPsec tunnels.
tunnel-id tunnel-id: Specifies an IPsec tunnel by its ID in the range of 0 to 4294967295.
Usage guidelines
IPsec transmits data in a secure channel established between two endpoints (such as two security
gateways). Such a secure channel is usually called an IPsec tunnel.
Examples
# Display brief information about all IPsec tunnels.
<Sysname> display ipsec tunnel brief
----------------------------------------------------------------------------
Tunn-id
----------------------------------------------------------------------------
0
Table 22 Command output
Field
Src Address
Dst Address
Inbound SPI
Outbound SPI
Status
# Display the number of IPsec tunnels.
<Sysname> display ipsec tunnel count
Total IPsec Tunnel Count: 2
# Display information about all IPsec tunnels.
<Sysname> display ipsec tunnel
Tunnel ID: 0
Status: active
Src Address Dst Address
192.168.0.61 192.168.0.64
Description
Source IP address of the IPsec tunnel.
Destination IP address of the IPsec tunnel.
Valid SPI in the inbound direction of the IPsec tunnel.
If the tunnel uses two security protocols, two SPIs in the inbound direction are
displayed in two lines.
Valid SPI in the outbound direction of the IPsec tunnel.
If the tunnel uses two security protocols, two SPIs in the outbound direction are
displayed in two lines.
Stateful failover status of the IPsec SA: active or backup.
This filed displays active.
Inbound SPI
54321
118
Outbound SPI Status
12345 active