HP 12500 Series Command Reference Manual page 30

GE5/0/2
GE5/0/3
GE5/0/4
Table 8 Command output
Field
Loadsharing Type
Port Status
Flags
Aggregate Interface
Aggregation Mode
System ID
Local
U 32768 1
U 32768 1
U 32768 1
Description
Load-sharing type:
•
Shar—Load sharing.
•
NonS—Non-load sharing.
Port state: Selected or Unselected.
LACP state flags. This field is 1 byte long, represented by ABCDEFGH from the
least significant bit to the most significant bit. The letter is present when its bit
is 1 and absent when its bit is 0.
•
A—Indicates whether LACP is enabled. 1 indicates enabled, and 0 indicates
disabled.
•
B—Indicates the LACP short or long timeout. 1 indicates short timeout, and
0 indicates long timeout.
•
C—Indicates whether the sending system considers that the link is
aggregatable. 1 indicates yes, and 0 indicates no.
•
D—Indicates whether the sending system considers that the link is
synchronized. 1 indicates yes, and 0 indicates no.
•
E—Indicates whether the sending system considers that the incoming
frames are collected. 1 indicates yes, and 0 indicates no.
•
F—Indicates whether the sending system considers that the outgoing
frames are distributed. 1 indicates yes, and 0 indicates no.
•
G—Indicates whether the sending system receives frames in the default
state. 1 indicates yes, and 0 indicates no.
• H—Indicates whether the sending system receives frames in the expired
state. 1 indicates yes, and 0 indicates no.
Name of the aggregate interface.
Mode of the aggregation group:
•
Static for static aggregation.
•
Dynamic for dynamic aggregation.
Local system ID, comprising the system LACP priority and the system MAC
address.
Information about the local end:
•
Port—Port type and number.
• Status—Selected or Unselected state of the port.
• Priority—Port priority.
•
Oper-Key—Operational key.
•
Flag—LACP state flag.
NOTE:
For static aggregation groups, only local information (without the Flag field) is
displayed.
25