HP 12500 Series Command Reference Manual page 22

Field
Unknown-speed mode, unknown-duplex
mode
PVID
Port link-type
Tagged Vlan
Untagged Vlan
Last clearing of counters
Last 300 seconds input/output rate
Input/Output (total)
Input/Output (normal)
Line protocol current state
Internet protocol processing
The brief information of interface(s) under
route mode
The brief information of interface(s) under
bridge mode
Link: ADM - administratively down; Stby -
standby
Speed or Duplex: (a)/A - auto; H - half; F - full
Type: A - access; T - trunk; H - hybrid
Description
The interface speed and duplex mode are unknown.
Port VLAN ID (PVID).
Port link type: access, trunk, or hybrid.
VLAN whose packets are sent out of this interface with a
tag.
VLAN whose packets are sent out of this interface
without a tag.
Time when the reset counters interface command was
last used to clear the interface statistics.
Never indicates the reset counters interface command
has never been used on the interface since the device's
startup.
Average input/output rate over the last 300 seconds.
Statistics of all packets received/sent on the interface.
Statistics of all normal packets received/sent on the
interface.
Link layer state of the interface.
IP packet processing.
Disabled indicates that IP packets cannot be processed.
For an interface configured with an IP address, this field
changes to Internet Address is.
Brief information about Layer 3 interfaces.
Brief information about Layer 2 interfaces.
Link status:
• ADM—The interface has been administratively shut
down. To recover its physical layer state, run the undo
shutdown command.
• Stby—The interface is operating as a backup
interface.
If the speed of an interface is automatically negotiated,
its speed attribute includes the auto negotiation flag,
indicated by the letter a in parentheses.
If the duplex mode of an interface is automatically
negotiated, its duplex mode attribute includes the auto
negotiation flag, indicated by the letter a in parentheses
or a capital A. The letter H indicates the half duplex
mode, and the letter F indicates the full duplex mode.
Link type options for Ethernet interfaces.
17