Lldp Admin-Status - HP 12500 Series Command Reference Manual

Field
IEEE 802.1 extended TLV
IEEE 802.3 extended TLV
LLDP-MED extend TLV

lldp admin-status

Use lldp admin-status to specify the LLDP operating mode.
Use undo lldp admin-status to restore the default LLDP operating mode.
Syntax
lldp admin-status { disable | rx | tx | txrx }
undo lldp admin-status
Default
The LLDP operating mode is TxRx.
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view
Predefined user roles
network-admin
mdc-admin
Parameters
disable: Specifies the Disable mode. A port in this mode cannot send or receive LLDPDUs.
rx: Specifies the Rx mode. A port in this mode can only receive LLDPDUs.
tx: Specifies the Tx mode. A port in this mode can only send LLDPDUs.
txrx: Specifies the TxRx mode. A port in this mode can send and receive LLDPDUs.
Examples
# Configure the LLDP operating mode as Rx for GigabitEthernet 3/0/1.
Description
IEEE 802.1 organizationally specific TLVs:
•
Port VLAN ID TLV.
•
Port and protocol VLAN ID TLV.
•
VLAN name TLV.
•
DCBX TLV (not supported).
IEEE 802.3 organizationally specific TLVs:
• MAC-Physic TLV. The switch cannot send this type of TLVs but can
receive them.
• Power via MDI TLV.
•
Link aggregation TLV.
•
Maximum frame size TLV.
LLDP-MED TLVs:
•
Capabilities TLV.
• Network Policy TLV.
•
Extended Power-via-MDI TLV.
•
Location Identification TLV.
•
Inventory TLV.
135