Installing The Shield; Figure 46: Alignment Of The Heat Deflection Shield For Evacuation Of Heated Air To The Front - ABB FOX615 Installation & User Manual

I N S T A L L A T I O N P R O C E D U R E S
3.8.2

Installing the shield

Heat deflection shield R7AI
installation
72
cold air
Figure 46: Alignment of the heat deflection shield R7AI for evacuation
of heated air to the front
Proceed as follows:
1. Turn the shield for heat evacuation to the rear or front (refer to
or Figure 46) whichever is appropriate for your installation.
2. Locate the fixing position of the shield in the 19-inch rack or within the
ETSI adapters above the FAMO1 or FAMO1-F (option) or above the
FOX615 subrack (refer to
3. Lift the shield into position and secure the shield with four M6 screws.
4. Tighten the M6 screws provisionally.
End of instruction
Please note:
For efficient heat evacuation of the heat produced below the FOX equipment
the installation of a heat evacuation shield (proper orientation) below the
cable tray is recommended (refer also to
heated air
Figure 6 and Figure 15 respectively).
Figure 4).
Figure 45

FOX615 Installation