Fox615 Equipment; Signal Cables - ABB FOX615 Installation & User Manual

I N S T A L L A T I O N P R O C E D U R E S
3.1.3

FOX615 equipment

3.1.4

Signal cables

38
Please note:
The packing of the FOX does NOT contain the following installation material:
→ Captive nuts (for the rack)
→ Screws to fix the subrack, cable tray, adapters etc. in the rack (captive
nuts)
The packages for the FAMO1 fan unit, FAMO1-F alarm unit, dual power sup-
ply connection box DUPF1, ETSI adapters, heat deflection shield etc. and
units are not shown in detail here.
Check the unpacked equipment before you start the installation:
• Check for complete consignment and for correct designation (refer to
ordering information).
• Check the equipment for damages due to storage, transport or handling.
• Check the backplane connectors (subrack) for damaged pins.
• Check the front (if any) and backplane connectors of the units for dam-
aged pins.
• Leave units in their protective ESD bags until you plug them into the sub-
rack.
Please note:
Do not throw away any pieces packed with the equipment; you might use
them later.
Please note:
There are no connectors packed with the units. The connectors and cables
are in separate packing.
Please note:
Keep the original packing of the components if you plan to move or dispatch
the equipment later; the original packing provides the best protection for the
equipment.
All external equipment connects via the connectors on the front panel of the
units to the FOX615 (unit and traffic interfaces, maintenance interfaces,
alarm and clock interfaces). ABB provides signal cables of variable length for
all traffic and system interfaces.
For the visual inspection of signal cables check the following:
• Mechanical condition of the connectors and the cables.
• The contact holes of the connector must be clean.
• Mechanical condition of the latching system of the units.
ABB provides cables with latching clips.
• The labelling (designation) of the cables must conform to the documenta-
tion of the installation.
Connector sets are provided for interfaces which are user configurable
(alarm interfaces). The sets contain the Molex connector frame and crimp
terminals.

FOX615 Installation