Figure 24: Cable Tray And Installation Of Wago Connector Blocks And Power Cables - ABB FOX615 Installation & User Manual

I N S T A L L A T I O N P R O C E D U R E S
Power supply cable installa-
44
s
Figure 24: Cable tray and installation of WAGO connector blocks and
power cables
Please note:
The order of the polarity (plus, minus) on the left side is reversed compared
to the order on the right side.
Please note:
Figure 24 shows the set-up for front connection of the external power supply
circuit(s).
It is also possible to implement the WAGO connector block (L, R) for rear
connection of the power supply circuit. In this case the power cables leave
the cable tray towards the front and the polarities on the WAGO connector
block appear reversed compared to the presentation in
To install the power supply cable(s) and connector block(s) on the cable tray
proceed as follows:
Proceed as follows:
tion
1. Select the left or right side of the cable tray for the best fit to your exter-
nal power supply circuit and place the FOX power supply cable on the
cable tray.
2. Align the power cable in such way that the WAGO connector block is
close to the front of the cable tray. The tail with the red and blue wires
and the TYCO connector look to the rear.
3. Locate the studs on the back of the WAGO connector block in front of
the fixing holes inside the side panels of the cable tray.
L
R
s
Figure 24.

FOX615 Installation