Dupf1 Alarm Interface; Figure 41: Dupf1 Alarm Interface Connection; Table 7: Dupf1 Alarm Input Interfaces Pin Connection - ABB FOX615 Installation & User Manual

I N S T A L L A T I O N P R O C E D U R E S
3.7.3.3

DUPF1 alarm interface

Alarm Interface
F3 F4
Alarm_in 1 Alarm_in 5
Alarm_in 2 Alarm_in 6
Alarm_in 3 Alarm_in 7
Alarm_in 4 Alarm_in 8
68
The DUPF1 provides a cable with a 4x2 way Molex connector for its alarm
signals. The DUPF1 alarms are connected to one of the 3 alarm interfaces
F3, F4, F5 on the FAMO1 or FAMO1-F, normally to the F5 interface. The
DUPF1 connects to the highest 2 inputs of the 4 alarm inputs provided via
the Molex connector:
Table 7: DUPF1 alarm input interfaces pin connection
DUPF1 interface
F5 Alarm
Alarm_in 9 not used
Alarm_in 10 not used
Alarm_in 11 Power supply PSC2 failed
Alarm_in 12 Power supply PSC1 failed
a. The DUPF1 alarm cable does not carry the GND potential. Only the wire with the
alarm signals is provided, using pin 5 and pin 6.
The DUPF1 alarm outputs are implemented as "breaking" contacts, i.e. the
alarm signals provide ground potential if the alarm is inactive.
50
m ov ing fa ns
re fe r to ha ndbook

Figure 41: DUPF1 alarm interface connection

Alarm active
open
open
fa n 4 8 VDC 1 9 " 1 U R2 A
3 7 9 7 0 0 0 3 2 1 1 1 7 4 3 4 7 3
2 0 1 1 W4 4
F 2 : Ala rm output F 3 : Ala rm inputs F4 : Ala rm inputs
1 -2 1 -4 5 -8
32
Connector Pin
Signal GND
8 4
7 3
a
6 2
a
5 1
22
F5
F 5 : Ala rm inputs
9 -1 2

FOX615 Installation