Cleaning And Maintenance - Remington MB4045AU Use & Care Manual

ATTACHING AND REMOVING THE BLADE
• To remove the blade press the blade release button found at the top of the
trimmer and push the blade cartridge upwards and away from the trimmer.
• To attach the blade, align and snap in place until it clicks.

CLEANING AND MAINTENANCE

• To ensure long lasting performance of the trimmer, clean the blades and unit
after each use.
• Ensure the appliance is switched off and unplugged from the power outlet.
• Do not use harsh or abrasive cleaners on the unit or blades.
• This product has washable blades. Ensure the blades are detached from the
trimmer before washing the blades.
• Do not rinse while the product is connected to the mains.
• Wash the blades under a running tap to remove any hair clippings.
• After rinsing under a tap ensure the blades are dry.
• Please note the main body of the trimmer is not washable and should be kept
away from water.
• After each use, it is recommended to clean hair from blades either by using
the cleaning brush or by rinsing the blades under running water. When
rinsing the blades it is necessary to lubricate them once dry. With the unit
turned off apply 3 drops of oil to the moving blade facing up, one drop on
each end and one in the middle, then switch the unit on for a few seconds to
distribute the oil, then turn the unit off and wipe off excess oil.
NOTE: Do not disassemble the blades.
TROUBLESHOOTING
The trimmer does not work when turned on:
• Trimmer must be charged for a full 4 hours initially.
Trimmer cutters do not move:
• The cutting unit may be dirty and clogged. Clean the unit as directed in
Cleaning and Maintenance section.
Trimmer does not hold charge:
• Fully discharge battery by running trimmer until it stops; then follow recharging
instructions (see Charging section).
9