ADTRAN TRACER User Manual page 3

61280.003L1-1B
EXPOSURE TO RADIO FREQUENCY FIELDS
This device is designed to provide a maximum power output of 100 mW.
This level of RF energy in itself is below the Maximum Permissible
Exposure (MPE) levels specified in FCC OET 65:97-01. The installation
of high gain antenna equipment in the system configuration may create
the opportunity for exposure to levels higher than recommended for the
general population at a distance less than one meter from the center of
the antenna. The following precautions must be taken during installation
of this equipment:
• The installed antenna must not be located in a manner that allows
exposure of the general population to the direct beam path of the
antenna at a distance less than one meter. Installation on towers,
masts, or rooftops not accessible to the general population is
recommended; or
• Mount the antenna in a manner that prevents any personnel from
entering the area within one meter from the front of the antenna
• During antenna installation, be sure that power to the Tracer
equipment is turned off in order to prevent any energy presence
on the coaxial connector.
• During installation and alignment of the antenna, do not stand in
front of the antenna assembly.
• During installation and alignment of the antenna, do not handle
or touch the front of the antenna.
These simple precautions must be taken to prevent general population
and installation personnel from exposure to RF energy in excess of
specified MPE levels.
6/18/98
P
AGE III