Advertisement
ASSEMBLY INSTRUCTIONS
(12)
(7)
MODEL# 9040MTH
x6 Assembled Legs
(10)
(9)
STEP 5:
Parts:
6x Legs with Caps (Part 12)
NOTE:
If the Caps from the Leg Poles are not
already placed after unboxing, make sure to
insert them on the opposite side of where
the openings are located as shown. This
will make sure that the openings are clear
when installing into the Frame. Repeat this
process until you have all six assembled
Legs with Caps.
STEP 6:
Place all assembled legs inside the inserts.
Align openings from the T-Sections &
Cross-Sections to the Legs.
STEP 7:
Parts:
4x 40mm Square Neck Bolts (Part 7)
4x Nuts (Part 9)
4x Washers (Part 10)
A. Insert a Bolt (7) from the outside of the
Tighten
Frame and secure tightly with a Washer
(10), & Nut (9). Make sure Bolt is fully
inserted.
B. Repeat this process until all legs in
T-Sections are installed properly and
securely.
NOTE:
Do not Tighten any Nuts from the Cross-
Section Pieces. Doing so will make it
difficult to install the Straight Poles.
Tighten
9
Advertisement
