Lan Settings; Lan Port Settings - Siemens HiPath 8000 Administrator's Manual

3.2

LAN Settings

3.2.1

LAN Port Settings

The OpenStage 60/80 provides an integrated switch which connects the LAN, the phone itself
and a PC port. By default, the switch will auto negotiate transfer rate (10/100 Mb/s, 1000 Mb/s
with OpenStage 60/80 G) and duplex method (full or half duplex) with whatever equipment is
connected. Optionally, the required transfer rate and duplex mode can be specified manually
using the LAN port speed parameter.
In the default configuration, the LAN port supports automatic detection of cable con-
>
figuration (pass through or crossover cable) and will reconfigure itself as needed to
connect to the network. If the phone is set up to manually configure the switch port
settings, the cable detection mechanism is disabled. In this case care must be taken
to use the correct cable type.
The PC Ethernet port is controlled by the PC port mode parameter. If set to „Disabled", the PC
port is inactive; if set to „Enabled", it is active. If set to „Mirror", the data traffic at the LAN port
is mirrored at the PC port. This setting is for diagnostic purposes.
When PC port autoMDIX is enabled, the switch determines automatically whether a regular
MDI connector or a MDI-X (crossover) connector is needed, and configures the connector ac-
cordingly.
Data required
• LAN port speed / LAN port type: Settings for the ethernet port connected to a LAN
switch.
Value range: „Automatic," „10 Mbps half duplex", „10 Mbps full duplex", „100 Mbps half du-
plex", „100 Mbps full duplex", „1 Gbps half duplex" (OpenStage 60/80 G), „1 Gbps full du-
plex" (OpenStage 60/80 G).
Default: „Automatic".
• PC port speed / PC port type: Settings for the ethernet port connected to a PC.
Value range: „Automatic", „10 Mbps half duplex", „10 Mbps full duplex", „100 Mbps half du-
plex", „100 Mbps full duplex", „1 Gbps half duplex" (OpenStage 60/80 G), „1 Gbps full du-
plex" (OpenStage 60/80 G).
Default: „Automatic".
• PC port mode / PC port status: Controls the PC port.
Value range: „Disabled", „Enabled", „Mirror".
• PC port autoMDIX: Switches between MDI and MDI-X automatically.
Value range: „Yes", „No".
A31003-01010-M11-1-7619, 29/01/2007
HiPath 8000 - OpenStage 60/80, Administrator Manual
administration.fm
Administration
LAN Settings
3-3