Connect The Preinstalled Mini-Sas X4 Cable - HP Apollo 4200 Gen9 User Manual

Populate drive bays based on the drive numbering sequence. Start from the drive bay with the lowest
device number.
24. Power up the server.

Connect the preinstalled Mini-SAS x4 cable

In this storage cabling option, the rear SFF drives 49-52 are managed by the Flexible Smart Array P840ar
Controller, while drives 53-54 are managed by the onboard Dynamic Smart Array B140i Controller. Both the
multiconnector drive signal cable and the preinstalled Mini-SAS x4 cable from the front drive cage 2
backplane will be in use.
Procedure
1. Release the preinstalled Mini-SAS x4 cable from the system board cable clips.
2. Remove the plastic cover from the released Mini-SAS x4 cable.
To show the location of preinstalled Mini-SAS x4 cable clearly, the six-bay SFF drive cage image is not
shown in following illustration.
3. Connect the released Mini-SAS x4 cable to port 1 of the rear drive backplane.
4. Secure the cable in the rear drive cage cable clip.
Connect the preinstalled Mini-SAS x4 cable 79