Installing A Hot-Plug Drive In The Front Drive Cage 2 - HP Apollo 4200 Gen9 User Manual

5. Determine the status of the drive from the drive LED definitions.
6. If removed, install the security bezel.
To configure arrays, see the HPE Smart Storage Administrator User Guide on the Hewlett Packard
Enterprise website.

Installing a hot-plug drive in the front drive cage 2

CAUTION:
Do not operate the server for long periods with the front drive cages extended. When the front drive
cages are extended while the server is powered on, do one of the following:
• If the iLO 08-HD Max sensor reading is reporting a temperature value, monitor the status of the front
drive health/thermal LED. When this LED starts flashing amber, immediately slide the drive cages
back into the chassis
• If the iLO 08-HD Max sensor reading is reporting an N/A value, monitor how long the drive cages
have been out of the chassis and keep them there for at least 300 sec before extending them out
again.
Failure to observe this caution will result in improper airflow and insufficient cooling that can lead to
thermal damage.
Procedure
1. Extend the front drive cages out of the chassis.
2. Open the drive release lever:
• LFF drive: Press the latch to open the release lever.
• SFF drive: Press the Do Not Remove button to open the release lever.
3. Install the drive:
• LFF drive
Installing a hot-plug drive in the front drive cage 2 63