Identifying The Contents Of The Server Shipping Carton; Extend The Front Drive Cages Out Of The Chassis - HP Apollo 4200 Gen9 User Manual
Hide thumbs
Also See for Apollo 4200 Gen9:
- User manual (193 pages) ,
- Maintenance and service manual (157 pages) ,
- Product end-of-life disassembly instructions (7 pages)
Table of Contents
Advertisement
CAUTION:
Do not operate the server for long periods with the front drive cages extended. When the front drive
cages are extended while the server is powered on, do one of the following:
•
If the iLO 08-HD Max sensor reading is reporting a temperature value, monitor the status of the front
drive health/thermal LED. When this LED starts flashing amber, immediately slide the drive cages
back into the chassis and keep them there until the LED turns green.
•
If the iLO 08-HD Max sensor reading is reporting an N/A value, monitor how long the drive cages
have been out of the chassis. Before reaching the 140 sec mark, slide the drive cages back into the
chassis and keep them there for at least 300 sec before extending them out again.
Failure to observe this caution will result in improper airflow and insufficient cooling that can lead to
thermal damage.
Identifying the contents of the server shipping carton
Unpack the server shipping carton and locate the materials and documentation necessary for installing the
server.
The contents of the server shipping carton include:
•
Server
•
Power cord
•
Rack mounting hardware kit
•
Printed setup documentation
In addition to the supplied items, you might need:
•
T-10/T-15 Torx screwdriver
•
T-25 Torx screwdriver
•
Hardware options
Extend the front drive cages out of the chassis
The front drive cages are secured to the chassis by shipping screws upon product delivery. The location and
number of these shipping screws depend on how the server was shipped during product delivery. Remove
these shipping screws before extending the front drive cages for the first time.
•
For a server that was already mounted on a rack during product delivery, there are two screws located on
the rack ears. Do the following to remove these screws:
1. If installed, remove the security bezel.
2. Remove the shipping screws on the rack ears.
Identifying the contents of the server shipping carton
27
Advertisement
Table of Contents
