Brother ADS-2200 Online User's Manual page 138

Error Message
Scheduled Maintenance
Alert
Sending Error
Server Time out
Setting Lock
Unsupported security
information
(Authentication
method/Encryption
method). Confirm
supported security
mode and try again.
Unusable Device
USB Access Error
USB Hub Not Supported
USB Write-protected
Wrong Network Key
Wrong Password
Related Information
• Troubleshooting
• Secure Function Lock 3.0
• Clean the Scanner and Rollers
• Replace the Pick Up Roller
Cause
The Pick Up Roller has been used over
5,000 times.
The Scan to FTP/SFTP profile, Scan to
Network profile or Scan to E-mail Server
is not configured correctly.
The machine was disconnected from the
Scan to FTP/SFTP profile, Scan to
Network profile or Scan to E-mail Server.
Adding a new shortcut was attempted
while the Setting Lock was turned on.
The security settings is incorrect.
An unusable device is inserted in the USB
port.
The USB flash drive was removed while it
was being accessed.
A USB flash drive with a hub is inserted in
the USB port.
The inserted USB flash drive is write-
protected.
The Network Key is incorrect.
The password entered in Setting Lock
was incorrect.
Action
See Related Information: Replace the
Pick Up Roller.
See Related Information:Replace the
Brake Roller .
Clean the Brake Roller and Pick Up
Roller. Paper jams and reduced scan
quality issues may occur if you do not
clean them.
See Related Information: Clean the
Scanner and Rollers.
Make sure the Scan to FTP/SFTP profile,
Scan to Network profile or Scan to E-mail
Server is configured correctly.
Configure the Network Settings.
Make sure the Scan to FTP/SFTP profile,
Scan to Network profile or Scan to E-mail
Server is configured correctly.
Configure the Network Settings.
Disable the Setting Lock.
Confirm the security settings and try
again.
Remove the device. Turn the machine off
and on by unplugging the machine from
the electrical socket, and then plugging
the machine in again.
Insert the USB flash drive.
Remove the unsupported device from the
USB port.
Remove the write-protected USB flash
drive, press Close, and then do one of
the following:
• Turn the USB flash drive's write-
protection off, and then try again.
• Use a USB flash drive that is not write-
protected.
Confirm the Network Key and try again.
Enter the correct password. If you forgot
it, you must reset it.
See Related Information: Set or Change
the Setting Lock Password.
134