Brother ADS-2200 Online User's Manual page 137

Error Message
Incorrect PIN
Insufficient USB
Storage
No Access Point:
No Certificate
No PC found
No Profile found
Not Registered
Remove documents.
Replace Pickup Roller
Cause
The PIN Number entered in Secure
Function Lock was incorrect.
The inserted USB flash drive is full.
The machine cannot detect a wireless
access point/router that has an active
WPS function.
The certificate does not exist, or is
corrupted.
The machine is not connected to your
computer.
No Scan to FTP/SFTP profile or Scan to
Network profile is registered.
(Scan)
The email address or SMTP server
address of the scan destination is not
registered.
(Secure Function Lock)
A user not registered in Secure Function
Lock is accessing the machine.
Auto Start Scan Mode was enabled
while a document was loaded.
All Rollers have been used over 100,000
times.
Action
• Clean the Pick Up Roller and Brake
Roller.
See Related Information: Clean the
Scanner and Rollers.
Enter the correct PIN Number. Contact
your administrator to check your Secure
Function Lock settings.
See Related Information: Secure Function
Lock 3.0.
Press Close, and then do one of the
following:
• Delete unused files or folders from the
USB flash drive, and then try again.
• Use a USB flash drive that has more
free space.
Check the following:
• You did not press the WPS button on
two or more wireless access point/
routers.
• Restart the machine and the wireless
access point/router.
Configure the settings under Signed PDF
in the Administrator tab in Web Based
Management.
See Related Information: Upload Scanned
Data to an FTP Server.
See Related Information: Upload Scanned
Data to a Mapped Network Drive (CIFS)
Server.
Connect the machine to your computer,
and then try again.
Configure the Scan to FTP/SFTP profile
or the Scan to Network profile before
using Scan to FTP or Scan to Network.
See Related Information: Set up a Scan to
FTP Profile.
See Related Information: Set up a Scan to
SFTP Profile.
See Related Information: Set up a Scan to
Network Profile.
Make sure the email address or SMTP
server address is correctly configured.
Contact your administrator to check your
Secure Function Lock settings.
See Related Information: Secure Function
Lock 3.0.
Remove the document, and then reload it.
Replace all rollers with new ones.
Scanning errors may occur if you do not
replace the part.
133