Skoda Octavia COMBI 2007 Owner's Manual page 70

WARNING
•
Only adjust the driver seat when the vehicle is stationary - risk of injury!
•
Caution when adjusting the seat! You may suffer injuries or bruises as a
result of adjusting the seat without paying proper attention.
•
In view of the fact that the seats can also be adjusted when the ignition is
switched off (even when ignition key withdrawn), you should never leave
children unattended in the car.
•
The backrests must not be angled too far back when driving otherwise
this will affect proper operation of the seat belts and of the airbag system -
risk of injury!
Note
If the movement of the seat is inadvertently interrupted during an adjustment, once
again press the switch in the appropriate direction and continue with the adjust-
ment of the seat to the end.
Storing setting
Storing seat and exterior mirror settings for driving forward
– Switch on the ignition.
Using the system Safety
Fig. 61 Driver seat:
Memory buttons and SET
button
Driving Tips General Maintenance
– Adjust the seat ⇒ page 68.
– Adjust both exterior mirrors ⇒ page 65.
A ⇒ fig.
– Press button SET 61.
A
– Press one of the memory buttons
the button SET - an acknowledgement signal confirms that the seat
setting is stored.
Storing exterior mirror setting for reversing*
– Switch on the ignition.
– Turn the exterior mirror control to position
– Engage reverse gear.
– Move the right exterior mirror into the desired position ⇒ page 65.
– Take the vehicle out of gear. The set position of the exterior mirror is
stored.
Memory buttons
Memory for the seat offers the possibility to store the individual driver seat and
external mirror position. An individual position can be allocated to each of the three
A ⇒ fig.
memory buttons 61, that is three in total. After pressing the corre-
B
A
sponding memory button , the seat and the exterior mirror are automatically
B
moved into the positions which have been allocated to this button ⇒ page 70.
Emergency Off
You can interrupt the setting operation at any time, if you operate any button of the
driver seat.
Note
•
When storing settings with the memory buttons, we recommend that you begin
with the front button and assign a memory button to each additional driver.
•
Each new setting stored with the same button erases the previous setting.
Breakdown assistance
Seats and Stowage
A
within 10 seconds after pressing
B
⇒ page 65.

Technical Data
69