Skoda Octavia COMBI 2007 Owner's Manual page 145

144 Communication
Voice command
The entered name or the last entered order of digits
is erased. Previously entered groups of digits are
BACK repeated. Then the system requests with voice
response "please proceed" the entry of further
digits or commands.
All entered digits are erased. Then the system
requests with voice response "The number is
DELETE
deleted. The number please" the entry of further
digits or commands.
CANCEL The dialogue is ended.
Enter PIN code
A PIN code must be entered before operating the system.
– Press the PTT button.
– Give the command ENTER PIN/PIN CODE after the signal tone.
After this command the PIN code can be entered.
The entry of the PIN code is only possible if:
•
the ignition and
•
the mobile phone is in the mount;
•
the mobile phone are switched on.
The digits zero to nine are permitted. The system detects no continuous digit
combinations such as twenty-three, but only individually spoken digits (two, three).
After each order of digits (separation through brief voice pause) the detected digits
are repeated.
Notes for entering the PIN code
•
When entering a PIN code with more than 8 digits, the system indicates "The
PIN is too long".
Activity
•
When entering an incorrect PIN code, the system indicates "The PIN is incor-
rect".
•
If the incorrect PIN code has been entered three times consecutively, the card
is blocked. With the aid of the personal unblocking code PUK (Personal Unblock
Key), the SIM card can be unblocked. The unblocking code can only be entered
via the phone keypad and not through the voice control.
Example for entering the PIN code
Voice command Announcement
ENTER PIN/PIN CODE "The PIN please"
e.g. ZERO ONE TWO THREE "Zero One Two Three"
If no entry is put in, the following announcement is made after about 5 sec-
onds.
"Possible commands are: store, repeat,
back, delete or more digits"
"The PIN is saved"
STORE
(end of dialogue)
You can interrupt the dialogue at any time by pressing the PTT button or with the
voice command CANCEL.
Select number
– Press the PTT button.
– Give the command DIAL NUMBER after the signal tone.
After giving this command, the system requests the entry of a telephone number.
The telephone number can be entered as an interconnected spoken row of digits
(complete number), in the form of order of digits (separation through a brief voice
pause) or through individually spoken digits. After each order of digits (separation
through brief voice pause) the detected digits are repeated.
The digits zero to nine are permitted. The system detects no continuous digit
combinations such as twenty-three, but only individually spoken digits (two, three).