WARNING
You should not leave recirculated air mode on over a longer period of time,
as "stale" air may result in fatigue in the driver and occupants, divert your
attention and also cause the windows to mist up. The risk of having an acci-
dent increases. Switch recirculated air mode off as soon as the windows
begin misting up.
Note
•
The whole heat output will be needed to unfrost the windscreen and side
windows. No warm air will be fed to the footwell. This can lead to restriction of the
heating comfort.
•
The used air streams out through the air removal openings in the luggage
compartment.
Set heating
Recommended settings of heating controls for:
Defrosting the windscreen and side windows
•
A
⇒ page 100, fig. 119
Turn control dial
A
•
A
Blower switch
in position 3
B
•
Turn the air distribution control
•
Open air outlet vents 3
window.
•
Close the air outlet vents 4
Keeping windscreen and side windows demisted
We recommend that you use the following setting in cases where the windows are
misted up more than usual (e.g. when it is raining):
•
A
Control dial
where necessary to the heating range
A
•
A
Blower switch
in position 2 or 3
B
Using the system
Safety
to the right up to the stop
A
into the position
C
⇒ page 102, fig. 120
and point towards the side
Driving Tips
•
A
Control dial
to
or
as required or to any desired position between
C
these symbols
•
Open air outlet vents 3 and point towards the side window
•
Close the air outlet vents 4
Warming up the inside of the vehicle as rapidly as possible
•
A
Turn control dial
to the right up to the stop
A
•
A
in position 3
Blower switch
B
•
Turn the air distribution control
•
Open the air outlet vents 3 and 4
•
We recommend that you briefly switch on the recirculated air mode with the
A
pushbutton
. The windows can steam up in this position however.
1
Heating the vehicle to a comfortable temperature
We recommend the following setting once the windows are no longer misted up
and the desired temperature has been reached:
•
A
Control dial
at the desired heat output
A
•
A
in position 2 or 3
Blower switch
B
•
Turn the air distribution control
•
Open the air outlet vents 3
•
Close the air outlet vents 4
•
Set the air distribution regulator
if the windscreen gets misted up again.
Fresh air mode - ventilation
Non pre-warmed fresh air streams through the air inlet nozzles 3 and 4 for the
following settings.
Recirculated air mode must not be switched on.
•
A
⇒ page 100, fig. 119
Turn the control dial
A
•
A
Blower switch
in the desired position
B
•
Turn the air distribution control
•
Open air outlet vents 3 and 4
General Maintenance
Breakdown assistance
Heating and air conditioning system
A
into the position
C
A
into the position
C
A
as required between positions
C
to the left up to the stop
A
into the position
C
⇒ page 102, fig. 120
Technical Data
101
and
,