Bluetooth Sensor Data; Connecting/Disconnecting Devices; Managing Devices - Motorola MTP8000Ex Series Feature User Manual

MN002041A01–AA
Chapter 5: Main Menu
5.6.6.3

Bluetooth Sensor Data

Your service provider can configure the details of the sensor information the radio displays.
Depending on the type of sensor connected to the radio and the setup configured by your service
provider, various types of information are displayed. The following sections contain information on the
most significant, pre-determined data the radio displays.
Sensor Battery Information
The radio displays the percentage of the remaining battery power of the connected sensors.
Heart Rate Sensor
If a heart rate sensor with the Energy Expended feature is paired and connected to the radio, two
values are displayed:
• Heart Rate in bpm
• Energy Expended in kJ
Sensor Alarm
A radio paired with appropriate sensors increases the security of the radio user by making the user
more aware of their surroundings. If the collected values exceed limits set by your service provider, the
radio plays an alarm tone, light the LED, and display a warning message. The alarm concerns, for
example, low battery, high toxicity, or low/high heart rate.
The alarm is active for a pre-defined time or until you discard it.
5.6.6.4

Connecting/Disconnecting Devices

Prerequisites: Only pre-approved sensor devices can be used. The service provider is responsible for
configuring the radio to work with specific devices. See "Adding Bluetooth Devices".
Procedure:
1 From the home screen, press the
2 Select Bluetooth → Devices.
3 Highlight the required device and press Connect or Disconnect.
NOTICE:
Depending on languages installed on the radio, some characters in names of devices
might not be displayed properly.
Radio-initiated automatic reconnection with remote Bluetooth devices cannot be
guaranteed to be successful in 100% of cases when several devices need to reconnect
at the same time, due to the fundamental nature of Bluetooth. In case the reconnection
fails after a power cycle (power off and power on of the radio), reconnect the device
manually.
5.6.6.5

Managing Devices

Procedure:
1 From the home screen, press the
2 Select Bluetooth → Devices.
102
key.
MENU
key.
MENU
Send Feedback