Delta RS830 Instruction Manual page 15

4. Loosen cutting-head clamp knob (S) Fig. 33, and
slide cutting-head (T) the entire length of track arm (A) as
shown to determine if blade (C) travels parallel to the
square (E).
5. If an adjustment is necessary, loosen index ring
locking screw (J) Fig. 34, and track arm clamp handle
(K).
6. Rotate track arm (A) Fig. 33, until blade (C) travels
parallel to square (E). Then tighten track arm clamp
handle (K) Fig. 34.
7. With track arm clamp handle (K) Fig. 35, tightened,
rotate index ring (L) counterclockwise until it stops. Then
tighten index ring locking screw (J) Fig. 36.
8. There are two miter index pointers, one of which is
shown at (M) Fig. 36. Adjust as follows: loosen screw (N)
and move pointer (M) until it lines up with the "zero"
mark on the miter scale (P). Then tighten screw (N).
Adjust the miter index pointer located on the other side
of column (R) in the same manner.
S
T
K
N
M
P
R
15
A
C
E
Fig. 33
J
K
Fig. 34
L
Fig. 35
J
Fig. 36