Sanyo SAP-KMV91G-S Technical & Service Manual page 75

Air cleaning filter
NOTE
How to install the air
cleaning filter
NOTE
Cleaning the main unit and
remote control unit
OI-306-25EG
Care and Cleaning (continued)
The air cleaning filter removes dust and dirt from the air, and reduces
odors and smoke from tobacco.
SAP-KMV91G
The air cleaning filter is included with the unit when shipped from the
factory. When purchasing a replacement filter, remove the dirty air
cleaning filter from the filter frame, and then mount the new filter. Do
not throw away the filter frame.
Ask for the STK-F4B model when purchasing.
SAP-KMV181G
The air cleaning filter is included with the unit when shipped from the
factory.
When purchasing a replacement filter, ask for the STK-F4B model.
The air cleaning filter cannot remove harmful gases or vapors nor
ventilate air in the room. You must open doors or windows frequently
when you use gas or oil heating appliances. Otherwise there is a risk of
suffocation in extreme cases.
The air cleaning filter needs to
be installed behind the
anti-mold filter.
1. Remove the anti-mold filter.
2. SAP-KMV181G
Set the air clean filter at the
mounting position with the
black side facing the rear.
SAP-KMV91G
Mount the air cleaning filter
in the filter frame in the
position shown in the
diagram with the (STK-F4B)
FRONT marking facing
towards the front.
3. Reinstall the anti-mold filter,
and close the air intake grill.
In general, the filter should
•
be replaced once every
three months.
Dirty air clean filters cannot
•
be washed and reused.
Purchase a replacement
filter at your local dealer.
Wipe clean using a soft, dry cloth.
•
To remove stubborn dirt, moisten a cloth in warm water no hotter
•
than 40 °C, wring thoroughly, and then wipe.
The air intake grille can be removed in order to wash it with water.
•
Air cleaning filter
SAP-KMV181G
Air cleaning filter
(with frame)
SAP-KMV91G
25