Sanyo SAP-KMV91G-S Technical & Service Manual page 63

NOTE
OI-306-13EG
Operation with the Remote Control Unit (continued)
To change the temperature setting, press the temperature setting
•
buttons and change the setting to the desired temperature.
Press TEMP. to change the temperature setting.
To raise the temperature
setting
To lower the temperature
setting
The temperature setting changes by one degree each time one of
•
the TEMP. setting buttons is pressed. The temperature setting may
be changed within a range of ±4 °C of the standard temperature.
(The temperature display changes back to the room temperature
display three seconds after the temperature has been changed.
However, the air conditioner remembers the new temperature
setting even when it is turned off.)
The type of operation and the temperature setting will differ
•
depending on the ambient temperature when operation starts, as
follows:
Operation type
Cooling
Dry
The temperature sensor of the indoor/outdoor unit automatically
•
selects cooling or drying operation.
(If you stop the air conditioner and then restart it within four hours,
the air conditioner operates in the same mode as before.)
Approx. 22 °C
Approx. 20 °C
The operation mode (cooling, dry) does not change automatically
•
during operation.
Although the fan speed is set automatically, you can change the fan
•
speed by pressing the FAN SPEED selector button.
To stop the air conditioner, press the ON/OFF operation button again.
Temperature
setting (Standard)
27 °C
Temperature when operation
starts (20 to 26 °C)
Indoor temperature
Approx. Approx. Approx.
15 °C 22 °C 27 °C
Drying
operation
Operation
lamp
Green
Orange
Temperature setting
(standard)
27 °C
Cooling operation
Temperature when
operation starts
(20 to 26 °C)
13