Table of Contents
Advertisement
Appendix
Battery
It takes up to 16 hours for the battery to be fully charged. When it is fully charged, you
can expect the following performance:
Operation
While in handset use (talking*)
While in speakerphone mode (talking*)
While not in use (standby**)
*Operating times vary depending on your actual use and the age of the battery.
**Handset is not charging or in use.
The battery needs charging when:
•
A new battery is installed in the handset.
•
The handset beeps every minute while on a call.
•
The handset beeps and Low battery displays on the handset.
•
Place in charger displays on the handset.
•
A battery is properly installed but the screen is blank.
CAUTION:
•
Use only the battery(ies) provided or equivalent. To order a replacement, visit our
website at www.vtechphones.com or call 1 (800) 595-9511.
•
codes for special disposal instructions.
•
Do not open or mutilate the battery(ies). Released electrolyte is corrosive and
might cause burns or injury to the eyes or skin. The electrolyte might be toxic if
swallowed.
•
Exercise care in handling batteries in order not to create a short circuit with
conductive materials.
•
•
Observe proper polarity orientation between the battery and metallic contacts.
•
of moisture.
Operating time
Up to seven hours
Up to seven days
71
Appendix
Expand your telephone system
The handset provided with your telephone system is pre-registered as
HANDSET. Additional handsets registered to the telephone system are
assigned in sequential order. If you register another new handset to your
telephone system, the new registered handset is assigned HANDSET 2.
This telephone system accommodates up to 12 handsets.
Add and register a handset (optional)
You can add new handsets (DS6301, purchased separately) to your
telephone system, but each handset must be registered with the telephone
Press and hold FIND HANDSET on base for 4 sec, then press # on
handset after a battery is installed. You may need to charge the handset
before registering to the telephone base. For more details on battery
charging, see the table on page 4.
To register a handset:
1.
Press and hold FIND HANDSET on the telephone base for about four
seconds until the red IN USE light turns on.
#
2.
Press
on the handset. Its screen shows Registering...Please wait and
it takes up to 60 seconds to complete the registration. The handset shows
HANDSET X Registered (X represents the handset number assigned)
and you hear a beep when the registration completes.
•
If the registration fails, the handset shows Registration failed for a few
seconds and then Press and hold FIND HANDSET on base for 4 sec,
then press # on handset. Try the registration process again.
•
You cannot register a handset if any other system handset is in use.
72
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
