Display Ipv6 Dhcp Client Statistics - HP A5120 EI Series Command Reference Manual

Description
Use the display ipv6 dhcp client command to display DHCPv6 client information.
With no parameters specified, the DHCPv6 client information of all the interfaces is displayed.
Examples
# Display the DHCPv6 client information of VLAN-interface 2.
<Sysname> display ipv6 dhcp client interface vlan-interface 2
Vlan-interface2 is in stateless DHCPv6 client mode
State is OPEN
Preferred Server:
Reachable via address
DUID
DNS servers
Domain names
Table 50 Output description
Field
in stateless DHCPv6 client
mode
State is OPEN
Preferred Server
Reachable via address
DUID
DNS servers
Domain names

display ipv6 dhcp client statistics

Syntax
display ipv6 dhcp client statistics [ interface interface-type interface-number ] [ | { begin | exclude |
include } regular-expression ]
View
Any view
: FE80::213:7FFF:FEF6:C818
: 0003000100137ff6c818
: 1:2:3::5
1:2:4::7
: abc.com
Description
Indicates the client is in the stateless DHCPv6 configuration mode.
Current state of the DHCPv6 client, which can be:

INIT: After enabled, the DHCPv6 client enters the INIT state.

IDLE: After receiving an RA message with the ―M‖ flag set to 0 and ―O‖
flag set to 1 and enabled with stateless DHCPv6, the DHCPv6 client enters
the IDLE state.

INFO-REQUESTING: The DHCPv6 client is requesting configuration
information.

OPEN: The DHCPv6 client successfully obtained configuration parameters
and completed stateless configuration based on the obtained parameters.
Information about the DHCPv6 server selected by the DHCPv6 client
Reachable address, which is the link local address of the DHCPv6 server or
relay agent.
DHCP unique identifier (DUID) of the DHCPv6 server
DNS server address sent by the DHCPv6 server
Domain name information sent by the DHCPv6 server
203