Vpn Popgo - HP FlexFabric 12500 Command Reference Manual

A tunnel policy specified in IPv4 VPN view or IPv6 VPN view is applicable to only the IPv4 VPN or IPv6
VPN.
IPv4/IPv6 VPN prefers the tunnel policy specified in IPv4/IPv6 VPN view over the tunnel policy specified
in VPN instance view.
Examples
# Associate VPN instance vpn1 with tunnel policy po1.
<Sysname> system-view
[Sysname] tunnel-policy po1
[Sysname-tunnel-policy-po1] tunnel select-seq lsp load-balance-number 1
[Sysname-tunnel-policy-po1] quit
[Sysname] ip vpn-instance vpn1
[Sysname-vpn-instance-vpn1] route-distinguisher 22:33
[Sysname-vpn-instance-vpn1] tnl-policy po1
[Sysname-vpn-instance-vpn1] quit
# Associate the IPv4 VPN vpn2 with tunnel policy po1.
[Sysname] ip vpn-instance vpn2
[Sysname-vpn-instance-vpn2] route-distinguisher 11:22
[Sysname-vpn-instance-vpn2] address-family ipv4
[Sysname-vpn-ipv4-vpn2] tnl-policy po1
[Sysname-vpn-ipv4-vpn2] quit
[Sysname-vpn-instance-vpn2] quit
# Associate the IPv6 VPN vpn3 with tunnel policy po1.
[Sysname] ip vpn-instance vpn3
[Sysname-vpn-instance-vpn3] route-distinguisher 11:33
[Sysname-vpn-instance-vpn3] address-family ipv6
[Sysname-vpn-ipv6-vpn3] tnl-policy po1
Related commands
tunnel-policy

vpn popgo

Use vpn popgo to specify the VPN label processing mode as POPGO forwarding on an egress PE, which
will pop the label for each packet and forward the packet out of the interface corresponding to the label.
Use undo vpn popgo to restore the default.
Syntax
vpn popgo
undo vpn popgo
Default
The VPN label processing mode is POP forwarding on an egress PE, which will pop the label for each
packet and forward the packet through the FIB table.
Views
BGP view
97