Static-Lsp Egress; Static-Lsp Ingress - HP FlexFabric 12500 Command Reference Manual

static-lsp egress

Use static-lsp egress to configure the egress node of a static LSP.
Use undo static-lsp egress to delete the egress node configuration for a static LSP.
Syntax
static-lsp egress lsp-name in-label in-label
undo static-lsp egress lsp-name
Default
No static LSP exists on the device.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
lsp-name: Specifies a name for the static LSP, a case-sensitive string of 1 to 15 characters.
in-label in-label: Specifies an incoming label in the range of 16 to 1023.
Usage guidelines
The static LSP must not have the same incoming label as an existing static CRLSP or static PW. If it is the
same, the static LSP will not be available, even if you modify the incoming label of the static CRLSP or the
static PW. To make the static LSP available, delete the static LSP, and reconfigure it with an unused
incoming label.
Examples
# Configure a static LSP on the egress node: specify the LSP's name as bj-sh and incoming label as 233.
<Sysname> system-view
[Sysname] static-lsp egress bj-sh in-label 233
Related commands
display mpls static-lsp

static-lsp ingress

Use static-lsp ingress to configure the ingress node of a static LSP.
Use undo static-lsp ingress to delete the ingress node configuration for a static LSP.
Syntax
static-lsp ingress lsp-name destination dest-addr { mask | mask-length } { nexthop next-hop-addr |
outgoing-interface interface-type interface-number } out-label out-label
undo static-lsp ingress lsp-name
22