HP FlexFabric 12500 Command Reference Manual page 133

Peer: 192.3.3.3
Signaling Protocol
Link ID
In Label
MTU
PW Attributes
VCCV CC
VCCV BFD
Tunnel Group ID
Tunnel NHLFE IDs
Table 41 Command output
Field
Xconnect-group Name
Connection
Peer
PW State
Wait to Restore Time
Remaining Time
PW Attributes
VCCV CC
VCCV BFD
Tunnel Group ID
Tunnel NHLFE IDs
PW ID: 500
: LDP
: 0 PW State : Up
: 65663 Out Label: 65662
: 1500
: Main
: -
: -
: 0x800000160000000
: 1026
Description
Cross-connect group name.
Cross-connect name, which is displayed for LDP and static PWs.
IP address of the peer PE of the PW.
PW state: Up, Down, Blocked, or Defect.
Blocked indicates that the PW is a backup PW. Defect indicates BFD has detected
a defect on the PW.
Wait time to switch traffic from the backup PW to the primary PW when the
primary PW recovers, in seconds. If the switchover is disabled, this field displays
Infinite.
This field is available when both primary and backup PW exist, and is displayed
only for the primary PW.
Remaining wait time for traffic switchover, in seconds.
PW attribute:
•
Main—Primary PW.
•
Backup—Backup PW.
VCCV CC type:
•
Control word.
•
Route alert.
•
TTL.
VCCV BFD type:
•
Fault Detection with BFD. BFD packets use IP/UDP encapsulation (with IP/UDP
Headers).
•
Fault Detection with Raw-BFD. BFD packets use PW-ACH encapsulation
(without IP/UDP Headers).
ID of the tunnel group for the PW.
NHLFE IDs of the public tunnels that carry the PW.
If equal-cost tunnels are available, this field displays multiple tunnel NHLFE IDs.
If no tunnel is available, this field displays None.
128