Bezel Blank
On some models, there is a bezel blank covering the external drive bay that needs to be
removed before installing a drive. To remove a bezel blank:
1.
Remove the computer access panel
2.
Remove the front bezel
3.
Push the two retaining tabs that hold the bezel blank in place towards the outer right edge of the
bezel (1) and pull the bezel blank inwards to remove it (2).
Figure 6-15
42
Chapter 6 Removal and Replacement Procedures
(Front Bezel on page
Removing a Bezel Blank
(Computer Access Panel on page
41).
40).