Specifications; Glossary - Porter-Cable C2002 Instruction Manual

What can happen
• Under some conditions and dura-
tion of use, noise from this product
may contribute to hearing loss.
Model No.
Bore
Stroke
Voltage-Single Phase
Minimum Branch Circuit Requirement
Fuse Type
Air Tank Capacity (Gallon)
Approximate Cut-in Pressure
Approximate Cut-out Pressure
SCFM @ 40 PSIG
SCFM @ 90 PSIG
Become familiar with these terms
before operating the unit.
CFM: Cubic feet per minute.
SCFM: Standard cubic feet per min-
ute; a unit of measure of air delivery.
PSIG: Pounds per square inch gauge;
a unit of measure of pressure.
Code Certification: Products that
bear one or more of the following
marks: UL, CUL, ETL, CETL, have
been evaluated by OSHA certified
independent safety laboratories and
meet the applicable Underwriters
Laboratories Standards for Safety.
Cut-In Pressure: While the motor is
off, air tank pressure drops as you
continue to use your accessory. When
the tank pressure drops to a certain
A15414
HAZARD
RISK FROM NOISE
SAVE THESE INSTRUCTIONS
FOR FUTURE USE

SPECIFICATIONS

GLOSSARY

How to prevent it
• Always wear certified safety equip-
ment: ANSI S12.6 (S3.19) hearing
protection.
C2002
1.875"
1.250"
120
15 amps
Time Delay
6
120 PSIG
150 PSIG
3.7
2.6
low level the motor will restart auto-
matically. The low pressure at which
the motor automatically restarts is
called "cut-in" pressure.
Cut-Out Pressure: When an air
compressor is turned on and begins
to run, air pressure in the air tank
begins to build. It builds to a certain
high pressure before the motor auto-
matically shuts off - protecting your
air tank from pressure higher than its
capacity. The high pressure at which
the motor shuts off is called "cut-out"
pressure.
Branch Circuit: Circuit carrying elec-
tricity from electrical panel to outlet.
8 - ENG