Processors And Heat Sinks - Dell Precision 7920 Rack Owner's Manual

Processors and heat sinks

Removing processor and heat sink module
1 Using Torx #T30 screwdriver, loosen the screws.
NOTE: Ensure that the screw is completely loosened before moving on to the next screw.
2 Pushing both retention clips simultaneously, lift the processor heat sink module out of the system
3 Set the module aside with processor side facing up.
Figure 13. Removing heat sink (2U)
Removing processor from processor heat sink module
1 Place the heat sink with the processor side facing up.
2 Insert a flat blade screwdriver into the release slot marked with a yellow label. Twist (do not pry) the screwdriver to break the thermal
paste seal.
3 Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.
46 Removing and installing components