Vflash Card - Optional - Dell Precision 7920 Rack Owner's Manual

Figure 22. Removing expansion card riser 3
Installing expansion card riser 3
Steps
1 Align the following:
a Tab on the riser with the slot on the system and guide rails on the riser with the standoffs on the side of the system.
b Lower the riser into the system until the riser edge connector engages with the connector on the system board.
The riser card edge engages with the riser guide on the system.
2 Using Phillips #2 screwdriver, tighten the screw to secure the riser to the system.
Next steps
1 If removed, install expansion cards into the riser and connect any cable disconnected.
2 If applicable, install the air shroud.
NOTE: If applicable, open the PCIe card holder latch on the air shroud to install the full length card.
3 Install any device drivers required for the card as described in the documentation for the card.
vFlash card – optional
Removing vFlash card
Prerequisites
1 If applicable, remove the full height PCIe card in expansion card riser 2.
2 If you are replacing the vFlash card, remove the micro SD cards.
Removing and installing components 57