Wvb Installation - DirecTV C61W User Manual

•
If one or more of the wireless clients' (C41W, C61W) network LED are not
green, the WVB2 will need to be relocated to an area that maximizes range
and minimizes interference. Refer to Troubleshooting section for more details.
•
If more than one wireless clients (C41W, C61W) will be installed and a
GREEN LED cannot be achieved on all wireless clients (C41W, C61W) the
technician has the following options:
7) Do not proceed if the signal strength is marginal (yellow network LED's on
the wireless client (C61W(s)) A yellow network LED on the wireless client
(C61W) indicates poor signal strength to the WVB2. Consider moving the
WVB2, adding another WVB or using a wired client.
D. WVB I
NSTALLATION
Once the WVB2 survey is complete and the optimal locations for the WVB2(s) and wireless
clients (C61W) have been determined, installation can begin.
1) If not previously performed, install the ODU/SWiM and run the coax cable to the
WVB location(s) (do not connect the coax to the WVB2 yet).
2) If not previously performed, install, update the software and activate the
Genie server
3) Connect the WVB2 to the SWiM/MoCA network (if more than one WVB2 is
used, connect all WVB2's to the SWiM/MoCA network)
4) If WVB2 is not powered on, power on the WVB2. After a short delay (less
than 1 minute) the LED should be Solid GREEN. Note: The LED will be
solid BLUE if the Genie server previously had ANY clients (wired or
wireless) paired to it. If not solid GREEN or solid BLUE refer to
Troubleshooting section. (Full boot takes about two minutes).
5) On the Genie server verify OSD "A wireless video bridge has been found
and configured successfully". Select OK to clear the OSD. This often takes
only 30 seconds however it can take up to several minutes.
Version 1.0.0 12/16/2016
•
Use a wired client (C41/C51/C61). Follow existing guidelines to install
the wired client if needed.
•
Use more than one WVB2. Choose a location for the first WVB2 that
covers most of the wireless clients (C41W, C61W) and choose
another location for a second WVB2 to cover the wireless client(s)
(C61W) that have poor signal coverage.
Page 19
User Manual –Wireless Video Bridge Gen 2