Creating A Sample Program - Siemens SIMATIC TD 200 User Manual

Configuring the TD 200
2.2

Creating a Sample Program

Click on the Ladder Editor to create and view your program in Ladder Logic. Click on the
Statement List Editor to create and view your program in Statement List format. Figure 2-18
shows a sample program in both the Ladder and Statement List editors. This program uses
the TD 200 configuration information from the example created in this chapter.
Download the program and data block to a CPU. Attach a TD 200 to the CPU to see the
messages created with the wizard. Use the following keys on the TD 200:
Press F1 to go to the setpoint message.
Press ENTER to edit the setpoint. Press ENTER again to go to the acknowledge
message.
Press ENTER to acknowledge the third message.
Press F2 to enable all three messages at once.
Press F3 to disable all the messages.
2-18
SIMATIC TD 200 Operator Interface
C79000-G7076-C205-04