Epson Stylus PHOTO 950 User Manual page 275

Message
(No message)
If you want to enable DMA transfer, follow the steps below.
1. For Windows Me, 2000, NT 4.0, 98 and 95 users double-click
the My Computer icon on your desktop and then Control
Panel.
For Windows XP users, click Start, then click Control Panel.
2. For Windows Me, 2000, NT 4.0, 98 and 95 users double-click
the System icon and click the Device Manager tab.
For Windows XP users, click Performance and
Maintenance, then click System, then click Hardware tab,
then click Device Manager.
3. Double-click the Ports (COM & LPT) icon and then the LPT1
icon. If your printer is connected to a port other than LPT1,
double-click the appropriate port icon.
Action
Your system's parallel port setting does not
allow DMA transfer. However, if you change
the parallel port setting to ECP or Enhanced
using your computer's BIOS Setup program,
you may be able to use DMA transfer.
Consult your computer manual or
computer manufacturer for instructions.
Once you change the parallel port setting,
follow the steps below this table to enable
DMA transfer.
Note:
Before you run the BIOS Setup program,
uninstall the printer software using
Add/Remove Programs in the Control
Panel. After running the BIOS Setup
program, reinstall the printer software.
Increasing the Print Speed
11
11
11
11
11
11
11
11
11
11
11
11
266