Ny-Series Instructions Reference Manual (W560 - Omron NY532-5400 Reference Manual

2 Instruction Descriptions
Sample Programming
In this sample, an NX-series Communications Interface Unit (NX-CIF210) is connected to an EtherCAT
Coupler Unit (NX-ECC203).
The unit number of the NX-CIF210 is set to 1.
Built-in EtherCAT port
EtherCAT Coupler Unit
NX-ECC203
The ER signal is turned ON if the SetER signal is turned ON for a no-protocol remote node that is con-
nected to serial port 2 of the NX-CIF210. The ER signal is turned OFF if the ResetER signal is turned
ON for the same remote node.
Definitions of Global Variables
Global Variables
Name
E001_NX_Unit_I_O_Data_Ac-
tive_Status_63
N1_Node_location_information
*1 On the Sysmac Studio, right-click an NX-series slave terminal unit, select Display Node Location Port, and
set the device variable. Refer to the Sysmac Studio Version 1 Operation Manual (Cat. No. W504-E1-07 or
later) for details.
2-1220
NX-series
Communications
Interface Unit
NX-CIF210
Data type
ARRAY[0..63] OF
BOOL
_sNXUNIT_ID
AT
ECAT://node#1/NX Unit
Usage of I/O data for 63 NX
I/O Data Active Status
Units.
125
Device variable to specify
---
NX-CIF210

NY-series Instructions Reference Manual (W560)

Comment
*1